Custom Saddle
Working Hand Wade by Keith Valley


Lets go get a job done in this handsome roughout Wade


Base Saddle - Roughout Wade
by Keith Valley
Stainless Steel hardware Flat Plate 7/8ths riggin
Gullet - 7 & 1/2H by 6 & 1/4W by 4
Guadalajara Horn
92 degree North West Quarter horse bar
7/8ths Flat plate riggin
15 & 1/2 inch finished seat
Cantle 12&1/2 inch wide by 4 inch high
Cheyenne Roll - 1 & 3/4 inch


Maker Keith Valley - Rough out Dorrance Wade saddle - Stainless Steel hardware - Hamley Flat Plate 7/8ths riggin - Gullet - 7 1/2 inch Hight by 6 1/4 inch Width (front) with 4 - Guadalajara Horn - North West Quarter horse bars - Seat 15 1/2 inch finished - Cantle 12 1/2 inch wide by 4 inch high with Cheyenne Roll - 1 3/4 inch Maker Keith Valley - Rough out Dorrance Wade saddle - Stainless Steel hardware - Hamley Flat Plate 7/8ths riggin - Gullet - 7 1/2 inch Hight by 6 1/4 inch Width (front) with 4 - Guadalajara Horn - North West Quarter horse bars - Seat 15 1/2 inch finished - Cantle 12 1/2 inch wide by 4 inch high with Cheyenne Roll - 1 3/4 inch

contact us about an order like this saddle.

 

 

Back The Bill Smith - page 25 The Working Hand Half Breed - page 27 Next